Engineer - Protection And Control Commissioning

JOB TITE: ENGINEER (PROTECTION & CONTROL COMMISSIONING)

RESPONSIBILITIES:

• Shall Witness the installation, testing and commissioning activities related to protection, DC & Fault Recorder carried out by the contractor for substations of 400/132, 132/11 kV."
• Supervision of following commissioning activities:
• DC scheme checks
• Trip circuit supervision verification
• Current transformer test by primary and secondary injection
• Voltage transformer test by secondary injection
• CT circuit verification primary injection
• Protection relay setting and configuration checks
• Feeder, transformer and Bus Bar Differential relay stability
• Main and back up protection relays test by secondary injection of Siemens, ABB, SEL and Alstom make relays
• Battery, Charger and battery monitoring equipment test
• Digital fault recorder testing ( Siemens, Quiltorl and Rochester make)
• Protection scheme verification of trip logic, inter trip logic, CBF and BBP scheme
• End to end testing of feeder protection relays
• Pre and post energization checks
• To follow up the pending item / snags during the testing stage & make sure that the substation will be energized without snags /pending items. Regularly follow up on snag and NODs to ensure the station is commissioning with zero snag.
• Shall conduct pre-energization checks to ensure smooth energization of the station without any incidents. Participate in energization & perform load test related to protection equipment.
• Shall review the as-built drawing received from contractors and prepare comments as per the defined timelines.
• To ensure all the commissioning activities carried out adheres to the standard safety procedures. Implement method statements and perform site visit and other on-site activities in line with the approved procedures.
• Shall conduct site visits on contractors request and ensure safe receipt of new equipment on site and provide site reports.
• To ensure non-disclosure of confidential information to anyone within or outside the Authority, during or after employment in DEWA.
• To follow and adhere to the OH&S Management System Manual as per DEWA's safety standards.
• To perform any other tasks as assigned by the reporting manager.
  
  

• Bachelors Degree in Electrical Engineering
• Diploma in Electrical Engineering
  
  

• Minimum 5 years experience for Bachelors degree holder
• Minimum 7 years experience for Diploma holder
• Problem solving skills to propose technical solutions
• Knowledge in International Standards (IEEE, IEC, BS)
• Proficiency in technical report writing