Process Engineer

Key Responsibilities

• Plan machining processes by studying work orders, blueprints, 3D models, wire frame models, engineering drawings, material specifications, reference planes, locations of surfaces and machining parameters.
• Applies statistical methods and performs stack-up calculations to determine optimized manufacturing processes in terms of safety, quality, repeatability and cost.
• Proactively resolves problems—technical, planning, or product quality—to maximize process repeatability, and minimize cost of production.
• Contributes and takes ownerships in the generation of PFMEA documents.
• Read and produce engineering drawings according to different international standards with a sound knowledge of GD&T
• Prepares/modifies technical drawings, specifications, calculations, visual aids and any other documentation for production instruction or fixture definition.
• Supports in the design and modification of tooling and fixtures.
• Delivers results on any business support project (i.e. cost saving, industrialization, NCR, Mods) on time and within budget.
• Prepare and maintain work Instructions to support production operators.
• Issues engineering official communication to production staff when an approved deviation is taken from work instructions.
• Works within the limits of authority as defined by the Manufacturing Engineering Procedures getting adequate approvals with deviations are required.
• Observes test cuts and FAIs during manufacturing processes
• Create or modify Process Flow Charts, covering all manufacturing process steps.
• Releases rework sequences in the ERP system, providing adequate instructions as required.
• Record and project manage all actions required to close any assigned engineering change proposal (ECP) successfully.
• Maintains an error-free configuration in the PLM and ERP systems for any assigned part numbers.
• Work independently with minimal supervision.
  
  

• Bachelor’s degree in aerospace, Automotive, Mechanical or Manufacturing Engineering Aerospace, Defense and Oil & Gas is desirable.
• PMP, Six Sigma or Lean Manufacturing certification preferred.
  
  

• Minimum 5 years of relevant experience in the aerospace or automotive industries.
• Demonstrated track record of implementing process improvement to enhance efficiency, eliminate waste and reduce costs.
• Experience using CATIA V5 and/or Siemens NX.
• Familiarity with non-conformance processes.